31.10.2026 by Viktor Siebert
Mitsubishi HF-H servo motors: “Machine is running”
„Maschine läuft 😊 Danke noch mals“
Original customer feedback in German. Translation: “Machine is running 😊 Thanks again.”
We received this feedback on 30 October 2026 from a manufacturer of drive components in Lower Franconia, Germany, after completion of its machine overhaul.
14 Mitsubishi servo motors overhauled
industrypart overhauled 14 Mitsubishi HF-H series servo motors for the machine. Their ball bearings were worn. The overhaul included replacing the ball bearings, cleaning the encoder discs and replacing the encoder buffer capacitors.
One motor also had an encoder fault, Alarm 2d. This encoder could not be repaired. The customer intended to fit an encoder of its own.
Workshop footage and feedback on operation
The photographs show an HF-H104S and an HF-H354S before and after repair. The video shows these motors on our test bench. After completing the machine overhaul, the customer confirmed that the machine was running. This feedback describes operation at the time of the message.
Thank you to our customer for the trust and kind feedback, and to our workshop colleagues for their work on the overhaul.
Technical background on the series
Our German technical article on overhauling Mitsubishi HF-H54S-A51 and HF-H104S-A51 motors describes a different repair case from the HF-H series.
Video with German narration.
Mitsubishi HF-H104S
Mitsubishi HF-H104S: before repair
Mitsubishi HF-H104S: before repair
Mitsubishi HF-H104S: after repair
Mitsubishi HF-H104S: after repair
Mitsubishi HF-H104S: nameplate
Mitsubishi HF-H354S
Mitsubishi HF-H354S: before repair
Mitsubishi HF-H354S: before repair
Mitsubishi HF-H354S: after repair
Mitsubishi HF-H354S: after repair
Mitsubishi HF-H354S: after repair
Mitsubishi HF-H354S: nameplate